There are many common faults in impact crushers, so the troubleshooting methods also vary. Below are four common fault排除 methods:
1. If abnormal vibration is found in the crusher (impact crusher):
1) It indicates that the material is too large, check the feed size.
2) Uneven wear indicates that the blow bar needs to be replaced.
3) The rotor is out of balance and needs adjustment.
4) Improper foundation treatment, check the anchor bolts and reinforce.
2. If the bearing of the crusher (impact crusher) heats up:
1) It indicates that the bearing lacks oil, add oil in time. Of course, too much oil can also cause the bearing to heat up, check the oil level when adding oil.
2) The bearing is damaged, replace it in time.
3) The cover is too tight, adjust the bolt properly, loosen or tighten as appropriate.
3. If the output particle size of the crusher (impact crusher) is too large:
1) It indicates hammer wear, adjust or replace the hammer.
2) The gap between the hammer and the impact plate is too large, generally adjust to 15-20mm.
3) Large feed particle size will also affect the output particle size.
4. If the belt of the crusher flips:
1) It indicates belt wear, replace the V-belt.
2) Due to belt assembly problems, adjust the pulleys to be on the same plane.
3) Pay attention to the quality of the V-belt itself.
This article comes from http://www.tombit.cn Original link: http://www.tombit.cn/soft/html/3942.html